The OMEGA® PHE/ORE-6510B submersible electrodes are
designed for use in drums, open tanks and streams. The flat
sensing surface is surrounded by a porous polyethylene reference
junction which minimizes fouling. Electrode installation and removal
done by a simple ¼ turn quick disconnect. The cable assembly’s
cap has ½ MNPT thread, which can be connected to a coupling
and support pipe. The pipe allows easy mechanical mounting
and protects the cable from the liquid measured. The resulting
assembly is lightweight for convenient handling when maintenance
is needed. ATC is available as part of the mounting assembly.
The flat surface design is well suited for applications with relatively
high suspended solids or where flocculation operations require low
Where only low velocities are present and coating is a problem, the
electrode can be mounted at a 45° angle facing the flow so as to
obtain increased scrubbing action across the measuring surface.
Specifications Maximum Temperature 87°C (190°F) CPVC body 100°C (212°F) PVDF body Available Options: “-HF” Fluoride resistant “-LC” Low conductivity “-GL” Ground loop, for additional cost
† All amounts shown in EUR Note: Comes complete with Electrode Care Instruction Sheet.
NOTE: Temperature compensation is not required with ORP electrodes.
Order electrode and mounting assemblies separately. Materials of construction must be the same.
Mounting Assemblies come with 3 m (10') cable with BNC connector.
For non-standard cable lengths up to 15 m (50') replace the suffix "-10" in the mounting assembly model number with the desired length in feet, add $2 per foot to the price. (Additional cost of $2.00 per foot applies to the entire length of non-standared cable).
Note: At the time of initial purchase, please order both electrode and mounting assembly. Mounting assembly includes insertion assembly and cable. If ordered with automatic temperature compensation (ATC), the temperature compensator is built into the insertion assembly. When electrode has expired, simply re-order electrode.
Part Number Builder
Build Your Part Number Below
Material select from: 65 for CPVC 65K for PVDF
Cable Length select from: 10 for 3 m (10 feet) 25 for 7.6 m (25 feet) 50 for 15.2 m (50 feet)
ATC Temperature Sensor select from: Nothing(leave field blank) for None PT100 for 100 OHM Pt RTD PT1K for 1000 OHM Pt RTD TH700 for Series 700 thermistor R3K for 3000 OHM Balco
Note: All combinations may not be valid, check spec sheet for valid part numbers.