RS-485 COM1 or COM2 Interface for PCs - Discontinued

CIO-COM485

See All Models Below

PLACE ORDER

RS-485 Serial Interface
COM1, COM2 or Any Other COM address
Software Enables TRx and Rx
Up to 56K Baud
Access to IR Levels 2-7

Description

The CIO-COM485 model has been discontinued. Please contact our DAS Engineering department for possible alternatives.

The CIO-COM485 adds a single EIA compliant RS-485 port to your computer. RS-485 ports support longer transmission lines than the more common RS-232 and have the ability to switch between transmit and receive signals at the connector. The CIO-COM485 serial interface is designed around the standard serial communications chip used in PC serial I/O ports: COM1 and COM2.

The CIO-COM485 may be set up as COM1 or COM2 by choosing the appropriate base I/O address and interrupt. The register which controls transceiver enable/disable is located at the board’s Base+7 address. Writing to Base+7 controls the transmitters while reading from the register reads the current status.

The CIO-COM485 is equipped with two DB9 connectors for RS485 9 pin connectors and cables. In addition, in compliance with RS485, pins 5 & 9 are tied together as are pins 4 and 8.

Place Order(Specify Model Number)

Part Number/Desc.

Qty

Description

CIO-COM485

Consult Sales

Availability:

RS-485 interface card

† All amounts shown in EUR