Description
The RD145/146 Series Recorders have been discontinued, please review the RD260 Series or the RD100A Series as possible substitutes or consult OMEGA's Temperature Engineering Department for other options.
SPECIFICATIONSCold Junction Compensation:Temperature units "J" thermocouple only
Accuracy:±1% span, mV input: ±2% span, thermocouple input (non-linearized)
Chart Drive:Synchronous moter
Chart Paper: 100 mm (4") writing width; 8 meters (25') long; fan fold at 4 cm (1.5"): olive color grid
Chart Speeds: By gear selection - .5, 1, 2, 4cm/min or cm/hr (approximately .2, .4, .8, 1.6 in/min or in/hr). Gear sets supplied
Channels/Pens: 1 or 2
Event Marker:Override event std.
Input Impedance: 2 MΩ typical
Source Impedance:Up to 20 KΩ
Ranges (JC Unit):0 to 100°C and 0 to 500°C. Note: With switch on mV, the mV ranges are 0 to 100 mV and 0 to 500 mV
Ranges (JF Unit): 0 to 250°F and 0 to 1000°F. Note: With switch on mV, the mV ranges are 0 to 100 mV and 0 to 400 mV
Range (mV Unit): 0 to 100 mV and 0 to 400 mV
Suppressed Zero: -20 to 100% (front panel access hole, mini blade); 0 to 500% (rear panel access hole, lower temperature range only), e.g., JC unit can be set to read 500 to 600°C
Elevated Zero: -20 to 100% (rear panel access hole, lower temperature range only), e.g., JC unit can be set to read -100 to 0°C (-100 to 150°F)
Normal Mode Rejection: 16 dB at 60 Hz
Panel Opening: 130 H x 144 W mm (5.12 H x 5.7" W)
Pen Lift: Manual
Power Requirements: 15 Vac ± 10% 60 Hz 1 Pen - 5.5 watts 2 Pens - 7 watts
Response: 0.5 sec full scale
Dimensions: 126 H x 140 W x 165 D mm (4.96 x 5.5 x 6.5")
Mounting:
Optional - Bezel, $53
Optional - Rack Mount, $41
NOTE: Product is Discontinued
† All amounts shown in EUR
Note: Each unit comes complete with one pen per channel, one roll og paper, and complete operator's manual.
Part Number Builder
Build Your Part Number Below
Option Descriptions:
(1)
Strip Chart Recorders select from:145 for 1-channel recorder
146 for Dual channel recorder
(2)
Input Types select from:MV for mV input
J for Switchable thermocouple/mV
(3)
°C or °F Ranges select from:Nothing(leave field blank) for Standard Unit
C for °C range-For J input only
F for °F-For J input only
(4)
Speed Types select from:HRS for cm/Hrs
MIN for cm/min
Note: All combinations may not be valid, check spec sheet for valid part numbers.
CLOSE
