Economical Ball Bearing Turbine Flowmeters With 37 Degree Flare Fittings

FTB-200

See All Models Below

±½% of Reading Accuracy
Ball Bearing Design for Economy
Deflector Cones Stabilize Low Mass Rotor for Increased Bearing Life
NIST Traceable Calibration Certificate Included for Water

Description

Click on this link if you need more information about a Flow meter.

OMEGA™ FTB-201 Series turbine meters have male flared-end fittings for easy connections. They are built to meet the performance requirements of MS 33656, though they do not carry a military specification. These units come with a mating 2-wire connector and can be supplied with the integrally mounted signal conditioners, shown in the to-order table below, to provide 4 to 20 mA, 0 to 5V, and factored pulse outputs.

37° Flare Installation Kits
Proper application of a turbine Installation kits for turbine meters with 37° flare end fittings consist of two lengths of stainless steel tubing cut to a length appropriate for the upstream and downstream straight pipe runs and flared at one end. Mating sleeves and nuts are included. The kits can be conveniently butt-welded into the piping system. Flow straightening sections may be provided with the installation kit. These kits are available in tubing sizes from ½ to 2".

These turbine meters are intended for clean fluid service only; where there is any doubt concerning possible particulate impurities in the process fluid, strainers are recommended. In addition, when using these units for fluids with viscosities other than 1 centistoke, special calibrations and universal viscosity curves are available – consult OMEGA’s sales department.

**Ranges**
Model	Linear Flow Range (litres/min)	37° Flare Fittings	Max. Op. Pressure (Barg)	Length (mm)	Nom. K Factor Pulses/litre
FTB-201	1.3 to 13.2	¾-16 UNF-3A	344	62	3430
FTB-202	2.8 to 28.4	¾-16 UNF-3A	344	62	2640
FTB-203	4.7 to 36	¾-16 UNF-3A	344	62	1580
FTB-204	6.6 to 60	7/8-14 UNF-3A	344	70	1080
FTB-205	9.5 to 110	1 1/16-12 UNF-3A	344	83	580
FTB-206	15 to 227	1 5/16 -12 UNF-3A	241	89	170
FTB-207	23 to 352	1 5/8 -12 UNF-3A	206	99	110
FTB-208	30 to 492	1 7/8 -12 UNF-3A	155	111	60
FTB-209	57 to 850	2½-12 UNF-3A	120	121	32

Specifications
Accuracy: ±0.5% of reading
Repeatability: ±0.1% of reading
Temperature Range: -268 to 232°C
Maximum Intermittent Overrange: 150% of maximum range
Materials of Construction:
   Body: 304 SS
   Rotor: 17-4 PH SS
   Bearings: 440C SS
Installation Kits: 340 SS, 1.7 mm thick
Electrical: Two-wire connector included
Max Pressure Drop: 0.34 bar

Place Order(Specify Model Number)

Part Number/Desc.

Qty

Description

FTB-201

€1.965,00

Availability: 9 weeks

Linear range water 1.3 to 13.2 l/m; End conections: 3/4-16UNF-3A liquid turbine flowmeters

FTB-202

€1.887,00

Availability: 8 weeks

Linear range water 2.8 to 28.5 l/m; End conections: 3/4-16UNF-3A liquid turbine flowmeters

FTB-203

€2.432,34

Availability: 8 weeks

Linear range water 4.7 to 36 l/m. End conections: 3/4-16UNF-3A liquid turbine flowmeters

FTB-204

€1.939,00

Availability: 9 weeks

Linear range water 6.6 to 60 l/m. End conections: 7/8-14 UNF-3A liquid turbine flowmeters

FTB-205

€1.990,00

Availability: 11 weeks

Linear range water 9.5 to 110 l/m. End conections: 1 1/16-12 UNF-3A liquid turbine flowmeters

FTB-206

€2.146,00

Availability: 8 weeks

Linear range water 15 to 227 l/m. End conections: 1 5/16-12 UNF-3A liquid turbine flowmeters

FTB-207

€2.344,00

Availability: 9 weeks

Linear range water 23 to 352 l/m. End conections: 1 5/8 -12 UNF-3A liquid turbine flowmeters

FTB-208

€2.345,00

Availability: 9 weeks

Linear range water 30 to 492 l/m. End conections: 1 7/8 -12 UNF-3A liquid turbine flowmeters

FTB-209

€2.764,00

Availability: 9 weeks

Linear range water 57 to 850 l/m. End conections: 2 1/2 -12 UNF-3A liquid turbine flowmeters

Signal conditioners. Order as a system if purchased with a turbine meter. Eg: SYS/FTB-201/FLSC-18B. Use table below to order

FLSC-18B

Consult Sales

Availability:

Signal Conditioner 4-20mA output requires 8-40V dc

FLSC-34

Consult Sales

Availability:

Signal Conditioner 4-20mA output requires 115 V ac

FLSC-28

Consult Sales

Availability:

Signal Conditioner 0-5 V output requires 8-40V dc

FLSC-35B

Consult Sales

Availability:

Signal Conditioner 0-5 V output requires 115 V ac

FLSC-51

Consult Sales

Availability:

Signal Conditioner Square Wave output requires 8-35 V dc

Installation Kits

FTB-K3

€508.78

Availability: 8 weeks

37 Degree Flare Installation Kits for FTB-201, FTB-202, FTB-203. 10" Inlet/5" Outlet Length

FTB-K4

€580.60

Availability: 8 weeks

37 Degree Flare Installation Kit for FTB-204. 10" Inlet/5" Outlet Length

FTB-K5

€670.14

Availability: 8 weeks

37 Degree Flare Installation Kit for FTB-205. 10" Inlet/5" Outlet Length

FTB-K6

€712.28

Availability: 8 weeks

37 Degree Flare Installation Kit for FTB-206. 10" Inlet/5" Outlet Length

FTB-K7

€893.29

Availability: 8 weeks

37 Degree Flare Installation Kit for FTB-207. 14" Inlet/6" Outlet Length

FTB-K8

€1,062.00

Availability: 8 weeks

37 Degree Flare Installation Kit for FTB-208. 17" Inlet/8" Outlet Length

FTB-K9

€1,863.00

Availability: 8 weeks

37 Degree Flare Installation Kit for FTB-209. 21" Inlet/9" Outlet Length

Order By Part Number

Part Number

Qty

Part Number

Qty

† All amounts shown in EUR
Note: If an integral signal conditioner is required please order as a system. Omega will scale the signal conditioner to the turbine meter.
Example: SYS/FTB-201/FLSC-18B, scaled system includes: Signal Conditioner, Enclosure, Turbine Meter and Fitting. No additional charge- just add the flowmeter and signal conditioner prices together. Use the table below to order