Click on this link if you need more information about Pt100.
RTD 100Ω sensor with built-in
transmitter and 1/8 NPT is
programmable by a computer.
The configuration kit required for
programming is M12TX-CONFIG.
This unique probe is ideal for
areas with space limitations where
traditional head connections
are too large to fit. The M12
thread design offers a secure
Specifications Body: Stainless steel AISI 316L Probe Length: 13 and 24 mm (0.51 and 0.94") Diameter: 3 mm (0.12") Probe Type: Thermowell AISI 316L SS Process Connection:1/8 NPT male thread or G1/8 thread Connection: M12x1 male in accordance to VDE0627 (output connection) Sensor: RTD PT100 class A up to 300°C in accordance to IEC751 Range: -50 to 110°C (-58 to 248°F) Tmax, Electronic: 80°C (176°F) Sensor Break Monitoring: Selectable: Upscale (>21.0 mA) or downscale (<3.6 mA) action Sensor Short-Circuit: Fixed to downscale (<3.6 mA) action Output: 4 to 20 mA Factory Default: 4 to 20 mA = 0 to 100°C (32 to 212°F) Permissible Load: 700 @ 24 Vdc [RLo= (Vsupply-8,5)/0,020] Response Time (90%): <50 ms Isolation In - Out: Non-isolated Power Supply: 8.5 to 32 Vdc (polarity protected) Environment Conditions: Temperature: -40 to 80°C (-40 to 176°F) (for plastic body) Relative Humidity: 0 to 100% EMC: In accordance to EN 61326 Degree of Protection: IP65 and IP67 in accordance to IEC60529 Accuracy: Transmitter: Maximum of ±0.2°C or ±0.2% of span Sensor: class A in accordance to IEC751 Temperature Influence (Deviation from 20°C): Maximum of ±0.3°C/ 25°C or ±0.3% of span/25°C Supply Voltage Influence: Negligible Range Configurations: It is possible set the input temperature range (span) by the M12TX-CONFIG configuration kit (PC with OS Windows® required) Zero Adjustments: Any value between -50 to 50°C (-58 to 122°F) Minimum Span: 50°C [if the zero value is set between one of these values: -40°C, -20°C, 0°C, 20°C, 40°C (-40°F, -4°F, 32°F, 68°F, 104°F), the minimum span is 20°C (68°F) rather than 50°C (122°F)] Sensor Error Compensation: Over 2 points (maximum 1% of span) Factory Setting: 0 to 100°C/ sensor break >21 mA (upscale) Response Time: Diameter 3 mm (0.12") <3.5 seconds, diameter 6 mm (0.24") <13 seconds (test in water to IEC751- time for reaching 63.2% of instantaneous temperature change)
† All amounts shown in EUR Note: Comes complete with operator’s manual.
M12 Series - Temperature Transmitter with 100 Ohm RTD
M12TX-CONFIG - Configuration Kit for M12TX